- Stock: 500
- Model: NanoVNA-H
- Weight: 0.20kg
Portable vector network analyzer
Shipping list:
1. NanoVNA host*1 (including 2.8-inch touch screen, 1000mAh battery)
2. 20cm SMA public-to-public RG174 RF cable *2
3. Type-C to Type-C cableX1
4. USB Type-C data cable *1
5. Simple instructions*1
6. Touch pen*1 7. Piddle*1
8. SMA simple calibration set LOAD *1
9. SMA simple calibration set OPEN *1
10. SMA simple calibration set SHORT *1
11. SMA female-to-female connector *1
Package size: 12*9.5*3.5cm
Package weight: 180g
Package method: carton NanoVNA-H PCB Upgraded Version
Features added after the update:
1. Lower power supply noise, less noise when using harmonics;
2. Built-in 1000mAh battery
3. Add a MicroSD card to facilitate the storage of test data;
4. Add RTC support;
5. Modify port names to Port1 and Port2
MicroSD supports up to 32GB and only supports SPI mode.
This is a DIY product that provides as perfect a vector network measurement function as possible on the size of the credit card.
It includes a 2.8-inch touch screen, 400mAh battery, TX/RX measurement,
which can measure the complete S11 and S21 parameters.
If you need to obtain S12 and S22, you need to manually replace the transceiver port wiring.
If there are any other imperfections, you can communicate with me.
Measurement frequency:
- 50KHz ~ 1.5GHz
- Radio frequency output: -13dbm (maximum -9dbm)
- Frequency accuracy: <2ppm
- Frequency stability: <0.5ppm
- Measurement range:
- Measurement range: 70dB(50kHz-300 MHz),(50dB (300M-900MHz), 40dB (900M-1500MHz));
- Port SWR: < 1.1
- Display: 2.8-inch TFT (320 x240)
- USB interface: USB type-C communication mode: CDC (serial)
- Power supply: USB 5V 120mA, built-in 400mAh battery, maximum charging current 1A,
can be used continuously for more than 4 hours
● Number of calibration points: 101 (fixed)
● Number of scanning points: 101 (fixed)
● Display tracking: 4, tag: 4, set save: 5 Measure S parameters,
voltage standing wave ratio, phase, delay, Smith circle diagram...;